The PWM duty cycle is specified by writing to the CCPR1L register and to the CCP1CON<5:4> bits. Up to 10-bit resolution is available. The CCPR1L

The 4x frequency multiplier can be used with the internal oscillator block to produce faster device clock speeds than are normally possible with an internal

The sequence of events for 10-bit address is as follows, with steps 7-9 for slave-transmitter: Receive first (high) byte of address (bits SSPIF, BF and bit UA (SSPSTAT<1>)

All of the devices in the PIC16F726 family offer ten different oscillator options, allowing users a wide range of choices in developing application hardware especially

Copy Firmware out of Microchip PIC16F873 The master controller (Processor 1) initiates the data transfer by sending the SCK signal. Data is shifted out of both shift

Microchip PIC16LF872 Program Copying To enable the serial port for Microchip PIC16LF872 Program Copying, SSPEN bit (SSPCON<5>) must be set. To reset or reconfigure SPI mode:

The powerful LIN hardware and software kit includes a series of boards and three PICmicro microcontrollers. The small footprint PIC16F722A are used as slaves in

The WREN bit, when set, will allow a write operation to data EEPROM. On power-up, the WREN bit is clear. The WRERR bit is set when a